Remove Key Wait 10 seconds?

[FXWG]

I got this message on my DIC the other day. I read the manual and it said that the car had a problem with the steering lock? Am I about to have a biger problem with steering lock I have read so much about? I have a 2000 vert if that helps any. Any replys would be appricated.
Thanks
Bobby

 

[LMN8R]

I've had that display once in my '98. I thought that the steering lock problem had been fixed by 2000. I could be wrong, but I'm pretty sure.

Greg

 

[CFour]

You must take the car to the Dealer for a "free fix" of the steering lock system this is what causes this trouble code. GMs fix is to disconnect the locking system.

 

[GreyGhost]

Steering Wheel lockup

I have had the same problem twice with my 2002. There is a bulletin from General Motors #01044. I was told it only covers 1998-2000. Also check GM Servoce Operations DSC851 dealing with replacement for #01044. This is a workaround procedure that involves disconnecting the battery and removing certain chips on the circuit board. This is only a stop-gap fix to get you on the road until the real problem can be researched and repaired. My mechanic (independent shop) is going through the process as we discuss it. I will let you know what he comes up with. Personally, I feel that GM is responsible.

 

[GreyGhost]

Steering Wheel lockup

I have had the same problem twice with my 2002. There is a bulletin from General Motors #01044. I was told it only covers 1998-2000. Also check GM Servoce Operations DSC851 dealing with replacement for #01044. There is a workaround procedure that involves disconnecting the battery and removing certain chips on the circuit board. This is only a stop-gap fix to get you on the road until the real problem can be researched and repaired. My mechanic (independent shop) is going through the process as we discuss it. I will let you know what he comes up with. Personally, I feel that GM is responsible.

 

[c4c5specialist]

Hi there,
There is also something else that is not usually considered.
If you loose battery power with a key in the ignition, or out, this message may sometimes occur.
This is due to a rehoming process of the locking actuator to BCM feedback.
If you had a battery voltage problem, I would suggest it is normal. If not, then I would have it professionally diagnosed.
Allthebest, c4c5

 

[atmmac]

My 97 did that too!

My 1997 Corvette did the same thing. My brother stalled it out and it said remove key and wait ten seconds. I didnt remove the or wait ten seconds and it was fine. Never had any problems with it since.