Recent content by 66 big block

no luck yet

Gerry what size I D are the pipes thanks John

looking for 2.5 pipes, covers, hardware for 427 thanks John

hi sal the 66 rockers are ribbed with black thanks john

looking for nos rocker panel mouldings for non sidepipe 66 thanks John

looking for nos 66 rocker mouldings non sidepipe car thanks John

what was turn around to get that great beauty back :upthumbs

on outlet side of pump of 427 brass fitting was loose took off and mangled looking o ring was in there put back with teflon tape got it tight to line up for line to carb now have leak at pump should there be an o ring in there or use something other than tef tape thanks John

when I pulled Carb off gaskets where wet so I dont think end of throttleshaft is prob now I have gasket on manifold ss baffle then carb still have leak maybe bad base on new carb ???? thanks John

checked carb this morning still leaked after sitting over night same spot pass side at throttle plate area under secondary diaphram carb is new dont know whats causing this p.i.t.a thanks for help John

used 7/16" freeze plugs fit snug tapped in

I had that set up too gaskets leaked plus I thinkI had a vac leak I just did what John said put gasket down first then ss baffle plate then carb ran car will check for leaks after I also blocked the two holes in heat passage JOhn

Ihave new 3370 holley installed and I get leak at base pas side what is the right set up for gaskets for 390hp sloted gasket is first then thin alum spacer then gasket and carb I get leak after it sits over night not when running thanks John

I had off road mufflers from allens ok but switched to magna flow sounds great without being annoying