Need to section in a piece of the rear deck & hoping someone is parting out a car or has some scrap pieces laying around. Need about a 10" x 10" piece of the left rear corner. Can be from either a coupe or convertible.
Thanks
Jim
No problem, I was planning to do the final fitting of the nose on mine Saturday. Sunday my daughter has a soccer game at 10. That leaves a few hours Sunday afternoon before the football games start
Jim
First make sure all of the bolts are loose. Everything bolted up before, right? Yes, the protrusion in the disk should be inside the hole on the bracket. There are two locating/guide holes under the door sill plugs. Use a drift or screw driver in each hole too move the body around to get the...
I bought some small plastic containers at a marine supply store, usually used to mix fiberglas resin. Once its poured out for use POR-15 says to seal the can immediately & not to return the unused material to the can. Make sure the lip of the can is clean & use some saran wrap otherwise you...
I bought 2 qts of POR-15 & 1 qt of Chassis coat & still have material left. Sor far I did the frame, cross members, front suspension, frame brackets, trailing arms, a bunch of bolts and some small parts. It really goes a long way.
If I were to do it again I would buy 2 pint cans & then a few...
THAT"S WATY TO MUCH!!! Stuff is expensive!!! I used 1 qt POR-15 to do two coats on the frame & most of the suspension, brackets & cross members. Still working on the first qt of Chassis coat. Buy the pint cans of POR-15, its easier to close up & yields less waste.
Follow their instructions, but...
I'll race ya to the finish :L Actually I haven't had time to work on the car in about a month. Had to finish up some work on the house. I used POR-15 on the frame as well. Make sure you wear some latex gloves or something similar. That stuff will not come off you skin very easily. Found V&PM...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.