Recent content by BPs vette

Still having same issue starts up runs and then stalls.

thanks for the reply I will check the ignition module. Thanks Tony Brian,

I have a 87 that stalls shortly after starting. I replaced the injectors and it still will not keep running. I have disconnected maf and one injector at a time and it stalled with no codes set. Please help. Brian,

Thanks for the replys.I was just wondering how wide is the clips maybe you can grind down a wrech so you can capture the clip under the housing. Brian,

I need to replace my radiator but I can not get the filter housing to come off.Feels like the nut retainers are spinning when I turn the the knobs.Any help any tricks to hold the clips under the filter housing. Thanks Brian,

I just went tru this make sure you have good gas. I filled up and shortly after my vette would not start. I Got a fuel pressure gauge to check pressure and noticed the gas did not smell like gas I drained 3 gallons of water out of the pressure gauge bleed until I got all gas I put in a couple of...

Thanks for the replies.I checked out the service bullitan and there is a valve stem seal kit p/n 12511890 that addresses this issue. I think I can get the tools I need. Thanks Brian,

I have a 1987 coupe that smokes on start up. Looking at the service bullitans there is a new seal kit for this issue. How much will this run me to have the seals replaced. Thanks Brian,