Recent content by douglasamariani

The first diagram I posted is for the linkage. The second diagram I posted is for the cover. #5 in the second diagram is your adjustment screw. If you can post a picture of the problem

There are adjustments for the headlights. If you look online you will find a lot of information pertaining to the headlights. One of the easiest things to do is to follow the linkage and see where it's binding up and then make the adjustments from there. Loosen the 3 bolts on the bracket in...

Put a test light between the wires going into your sending unit for the fuel pump circuit and then crank the car and see if it lights up. If it does then your problem is with the new fuel pump. You can also dry test it and see if the fuel pump motor is spinning.

Very nice good luck with it

No it won't hurt the computer ,but the computer is not performing the way it was intended.

The distributor is where it gets its signal. If you have the original distributor reinstall it plug it in and you should be fine.

Happy New Years Everyone (y)

Merry Christmas Tom (y)

Merry Christmas Everyone

If a belt or belts were loose then yes they will come off the pulleys. Most likely the cause of your problem was a loose belt which took the other one with it when it came off. Reinstall the belts and make sure they have the proper tension.

Charge the battery and then disconnect the positive cable and let it sit for a couple of days. If the battery is dead then you have a defective battery. If the battery stays charged then you have a parasitic draw.

Add about 5 gallons of gas to the tank and then Prime the carburetor and see if she will start.