i bought new motors and ribbions, new felts and wipes for the windows; i just need to get new windows and i'll replce it all and maybe upgrade to newer regulators
Hello! I looking for a link to a page or sight where i might find instructions in replaceing these window motors. I'm afraid I might be heading down a long path with this one so any help is greatly appreciated
thanks brian
remove the wireing from the low pressure switch, jump the wire with a paper clip or pc. of elec. wire. while the motor is running this will override the LPS, and allow you to fully charge your system, ( i set mine at 40psi and it works fine. ) after chargeing ---reatach the wireing to the LPS...
I bypassed the relay and ran a red wire from the fuse box to a switch mounted under the steering colum then to the fan. normally the relay would close at 190 or better, but i get better performance between 174 and 184, this way the fan is on all the time while i'm driving. When i first start...
chances are, it was put there to eliminate the sqeeks, I need to replace all the weather stripping on my 84, not all of it squeeks but some do leak. The Hatch back window, does alot of moving around when i'm driving, and the noise drives me insane! being old it has harded a bit and now instead...
been there
On my 84 i have the brake to my left, I climb over it to enter the car, at the base of the handle there is a coil spring which I had to push (bend) back a bit to open the circut causing the light to stay on. i don't know about your 91, but it could work on the same principle, Hope...
Hello Glad to be here! :beer How is everyone summer? This is my first Vette and first season haveing her on the road, i'll post pic,s when i figure out how that is done, :w
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.