Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by KLUTZ

  1. K

    Help! C3 build sheets

    Well then, someone had better tell the fella who put it under the carpet behind the seats in 1973.... 'cause that's where I just found mine. ;)
  2. K

    Transmission Detent cable broken at connector... Repair possible?

    Another thing I'll have to address with my new to me '87 is that the plastic end piece that hooks to the throttle assembly is broken. The piece is there but the part that hooks on is gone. Is there any way these can be repaired to keep in use or does the entire cable have to be swapped out...
  3. K

    Rear intake duct availability..

    Don't forget.. I don't live in the Corvette Mecca of the world here. :D There are places to get it but Ebay ($31.00 shipping????) and the places that are here would need to order from the US anyway and that would take a couple weeks. BUT. Even though I have read some pretty questionable...
  4. K

    Rear intake duct availability..

    I called my local GM dealer and was told that these were discontinued. Why, who knows. I am having no luck locating one locally and may have to wait a week or so before I get get one. I am looking at these...
  5. K

    I know Service part ID's Z51 and Z52 but...

    So, what can I expect the ride to be like with mine when I get it roadworthy? Soft, hard, bumpy, rearend sway?
  6. K

    Vacuum lines to no where.. What do they connect to?

    Great. That is what I figured. After looking at the connector again, the back connector on the three way "Bulb" is broken off, that's why it didn't make sense to me. Can I buy that connector at any auto parts store or do I have to get it from GM?
  7. K

    Vacuum lines to no where.. What do they connect to?

    Among the cut wires and hoses not being where they were supposed to be, I have come across three, I believe vacuum tubes that I can't figure out where they go. The first one goes to the canister area in the front driver side corner and has this on the end. It reaches near the rear of the...
  8. K

    I know Service part ID's Z51 and Z52 but...

    Well, that answers that. :) Thanks
  9. K

    I know Service part ID's Z51 and Z52 but...

    What is this Z31 on my '87's build sheet? Is that the stock suspension ID#? I can't find it listed anywhere.
  10. K

    Where is the Left side actuator relay?

    The driver side motor went up when I plugged THAT side into the relay to/from the passenger side. And I did the opposite with the passenger side. No work. That is why I am thinking that the fusable link on the red wire to the driver side is faulty. It says something about "Heavy duty...
  11. K

    Where is the Left side actuator relay?

    Wonderful. Thankyou so much...
  12. K

    Where is the Left side actuator relay?

    Thanks Boom. I have a FSM on the way already. Should be here this week I hope. The relays are all fine and the motor is good on the one that won't operate. I plugged the driver side headlight pod feed into the passenger side relay, with the feed from the passenger side, and it went up. As...
  13. K

    Where is the Left side actuator relay?

    Hummm.. Ok I have power to the red and yellow on the wiring going to the passenger side relay, but only power on the yellow wire going to the drive side pod. It sounds like there must be a fuseable link in there somewhere but where? Could I tap into the red going to the passenger relay and...
  14. K

    Where is the Left side actuator relay?

    I have found the three of them and isolated the driver side relay. What I'm doing: Doing some electrical tracing on my '87 Vette and I'm trying to figure out why the driver side headlight pod isn't getting power. The headlight goes on, but the bucket won't move. I checked for power at the...
  15. K

    After 14 years, my "New to me" Vette started... Guess I should carry on?

    Probably should have but I checked it first and it was nice and clean and didn't "Appear" to have broken down, but I only had it run a few seconds. I'm making a trip to the goodie store tomorrow to grab a bunch of things including oil. What would be a good grade as it won't be driven at all...
Back
Top Bottom