Recent content by kmckenzi

Resolved Finally Finally got around to looking at this. Was checking grounds, connections etc. Now the car doesn't fire. Someone on another forum suggested pulling the 4 wire connector from the ECM to the distributor. Still no fire. When I reconnected, it check the ground connection on...

I'll check grounds and try the jumper and see what happens. Thanks! Sent from my SM-G920V using Tapatalk

OK pulle ecm and cleaned connectors. Pretty nasty. Went ahead and changed o2 sensor. Pretty nasty. Same. Hooked up dwell sits at around 33. I know the MC is working I can see it. When I giose the throttle check engine flashes and engine stalls. Bad MC Solenoid?

Been away. Solenoid checks at 21.8 ohm Sent from my SM-G920V using Tapatalk

Thanks all. Seems my batteries in my ohm/voltmeter are toast. I'll check resistance and my manual. Sent from my SM-G920V using Tapatalk

Sorry. Gauges are good Sent from my SM-G920V using Tapatalk

That's codes Sent from my SM-G920V using Tapatalk

Yes gauges are food. Yes I hear it clicking when reading the xodes Sent from my SM-G920V using Tapatalk

1981 stock corvette, 87K. Last month or so, idles up fine, runs ok on the road until it’s warmed up. Check engine lite comes on and it dies. Cranks back up and does it again within 5-10 minutes. I replaced the fuel filter (pretty nasty) and I still get it. Today I took it out. After...

I found it at the local Autozone. It's one of 2 Sylvania bulbs. I just bought both and one of them worked.

Thanks for the help. I'll check the hoses and see if fluid is getting thru. I'd like to replace calipers/hoses/rotors but don't have the $800 to do it. If I can nail the exact problem down, won't have to spend to much I hope.

81 Vette, everything still original, 68K miles. Got in the car yesterday and driving down the road the car pulls right. When I hit the brakes, pulls to the left. Put the front of the car up on jacks, both wheels spin ok, though the left might grab a little. Hoses look good. Pulled the...

Shifter moves...did'nt push the button down far enough. Looks like the bearing did seize. Time for more fun.

Thanks for the quick reply. The shift lever doesn't move at all. I'll check the bearings on that side but what we keep the shift lever from moving?

I have a stock 81, auto transmission and something bad happened. I noticed a thumping noise on the driver's rear while in reverse. Ocasionally it would grind. I put the car on jacks, and popped off the wheel. I started the car and put it in reverse. Passenger side looked/sounded good, but...