Recent content by Marv02

We are buying a New House and needed the money I can live in a New home But I can live in my old C4 Sorry family comes first. It been adventure thats for sure. Next project will be a 34 Vicky but this be a whlie a long while. :w:w:w

Vett against F-15. Oh ya I might be selling the Vett need the money for the new house.

Question I know the pushrods are a little bit on the longside when rolling the motor over and checking for patter wear on the valve stemtip it not completely center it on more the exhaust side more than center Iusing the stock length push rods 7.195 Do you think this could be the problem...

Swapped the gear out fired the car up the noise still there. I dont want to pull the motor again. I just dont get it. After the car is good and warm no noise. I went to McDee's drive though on the way to work this morning you could hear the knocking noise very well as it echoed off the wall next...

You can use a pump to add the fuild or just buy a long hose stuff one end in the fill hose bring the pther out the whell well put a funnle on this end just pour the oil in untill it starts comming out the fill hole. For the addtive put some oil in the diff stop pour the addtive inb the oil...

I just ordered a OEM GM melonized distributor gear. When I built the motor others said the composite gear was the way to go now I reading GM saying for a LT4-Hotcam go with the melonized gear set. I going to give this a try and see how this gear holds up compaired to the high dollar composite...

I pulled the cap NO hitting at all the rotor seen better days I change that I also pulled the distributor out and checked the end play it's at .017. The Composite distributor gear is showing wear about half the teeth are worn though already with 7000 miles on it sounds funny to me also the lower...

The noise is back. I am going to delete the 9th injector and see if this helps like I said before it only makes the noise when it is cold start up.

Then look at theses. Chevy Corvette (89-96) Radiator

I have a OEM rad sitting in my garage if pay for the shipping you can have it it out my 86 Vett.

It helped out a lot it made a very loud knock before with the old PR during cold start up and was not as bad when warm but now it sound almost normal now.

Did a cold start up this morning much much bettter there still a little noise but unles you were purpose listening for it you never notice it. I going to order a new FPR diaphragm and see if this will completely get rid of all fuel rail noise.

Take at look at this radiator. Chevy Corvette Radiator

When I got home from work today my new pulse dampener was at the door It took about 30 minutes to install it fired the car back up Idove it to work today it seems much better. I find out more after the car sits and I can start it cold thats when it made the noise the worse. But so far so good.

I was chasing a knocking sound in my Vett for a while now it’sbeen tracked down to the Fuel Pump Regulator. It holds 43 PSI of pressure at Idle But as soon as you turnthe engine off it drops to Zero. It has almost NEW FIC Bosch III 24# injectors and same forthe Fuel pump a Walberg 190...