I can send more pictures what are you interested in, let me know. I will send more info and pictures. I am at work until wednesday and will give more info after that is there anything special or just a more indetail on the car
Lots done to this vette, have receipts for all. Highlights are new GMZZ4 engine 350HP only 20,000 miles, a 700R4 transmission maybe 10 hours, new brakes, a full rebuilt front suspension, and the interior is 95% complete. Fun and fast you will love to drive this car. The only think left is paint...
here's the latest I tried all the tricks you guys suggested and i thought the gage started working which would mean bad connection or wire, but when i filled it up today it went way past full like when you disconect the sender. I will drive it around a while and see what happens if the guage...
I need a little help finding a part. I am replacing my t-top center panel and when i took the old one of i noticed that the velcro piece on the metal was not there, I have no idea what it is called or where to find one I have look at the common vette catalogs and nothing. Im not looking for...
I tried your idea when I pulled the sender wire off it went stright pass full i then hook up the test light and it did not move, I checked the ground it is good and i am getting a reading on the testlight so is it a wire problem or possible the circut panel behind the gages thanks for the help
I am loosing my mind I have put in a new sending unit and gage, check the ground by the tail light(Is there another one i don't know about) but no matter what i do the gage only works the top half of the tank in another words when the tank is full the gage reads full but when the tank is half...
My fuel gage reads full when i fill up the tank and as i am driving around go's down like it should but it is only reading 1/2 tank when it shows empty there is still 1/2 tank left I already replaced the sending unit. pleas does any one have any suggestions thanks
First I want to thank everyone for there help. You can test the sending unit outside the tank just hook it up like normal and have a buddy move the float it will give you a general idea that the system is working properly. Someone (no idea who it could of done it) didn't notice that when I put...
I pulled the sending unit back out and it does not look like it was caught on anything. I will check to see about the liner. Another question while I had it out I hook it up to see if it worked outside the tank and it did not work, the power and ground was still going to the sending unit but no...
Thanks, I tested it again using the 12v test light and it showed full again
I plan on taking it out to check to see if it is stuck on something in the next couple of days
I just put in a new sending unit in a 81. All it shows is empty. I did the test with grounding out the sending wire, it went all the way pass full, plus if I just disconnect the sending wire it stays pass the fuel mark. I'm I missing something or just not getting it?
I heard that the new...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.