Recent content by muzy67

I did notice the black insulation to the sensor(between the sensor and bracket) was cut open but the wires themselves didn't look damaged. I rewrapped w/ elec tape. I will double check the cleanliness of the sensor and the wires again to be sure.

'86vette-I just replaced my hub bearing(dvr side) and NOW my ABS seems to be acting up. On start up-normal, 4mph test normal, than on acceleration(over 5/6mph) the module or pump starts humming for about 10 sec and then the "anti-lock" light illuminates. I did use vasoline when installing the...

I have been doing some reading on other forums and it's not clear but I think I may have found my problem. I have an '86. The seal has been discontinued for some reason. I guess the only component between the spindle and the hub is the washer. The seal, which is metal and about 1/4" thick should...

I am having a problem on installation. The inner seal p/n 14046941 does not seat on the washer that is on the shoulder of the bearing. There is a gap between the two due to the knuckle housing id being smaller in dia than the seal od. Does this SEAL press into or take up the space between the...

I've searched previous posts and cannot find what I need. I have an '86 conv. and I am replacing my hertz top. The manual says to remove headliner and some weather stripping. I just want to know if there is a way to replace top without having to remove the w/s and ruining. I took it to an...

I seem to be having problems with my 5a LCD fuse blowing. I took my cluster apart and found a suspicious(burnt) transitor. Viewing from back, face down, it is located in the upper R/H area. It looks like the power grid in that it is on a 2"x3" stand off grid just below the pin connectors for...

I just replaced my battery and encountered this problem. My instrument cluster was working before batt change. I do have problems with backround lights not making good contact within cluster but it has been manageable and I have been OK with that problem. My LCD display is visible w/o backround...