Hey All,
Just wondering if this bracket kit is what I am looking for:
http://store.summitracing.com/partdetail.asp?part=ZOP%2D8000&autoview=sku
I have an 81 vette with the stock A/C compressor, and wasn't sure if this kit would fit or not.
Are there any other brackets that will fit the stock...
I suppose I'll just be left to paint the originals, that is all that is wrong with them. I was just worried about the paint not matching the header bar.
Thanks for all the help,
-Chris
I also bought the center section and that fits fine too. But the side pieces don't even look like the original. The cut out for the vin is smaller, there is a black stripe on the edge near the windshield, and they are a bit longer than the originals.
Dave do you think you could post a picture...
I have sent back one set of trim panels that didn't fit, and have just gotten a second set that doesn't fit, and before I try a third set, I thought I would ask if anyone here knows where I can get trim panels that would fit.
-Chris
Thanks for the kind words guys!
Yellow77: Bring your car up to Maine and I would be glad to =) this project was more fun then rebuilding the engine.
vette737: I used Rustoleum for almost everything, the Red is Hightemp engine paint, I used that so the red would match my engine, but also to...
Here is a picture of what I am talking about,
The bushing that is marked had a sleeve on the outside of it when we removed the old bushing. Do I need another one of these sleeves, for the new poly bushings, or not? also if I need one where can I get one? I see that the sleeve comes with the...
Hey guys,
I am replacing the bushings to for mounting the rear end, but the new poly bushings don't look like they are going to fit with the those sleeves in. I did a quick search and came up with this thread...
If it's like my 81 I'm pretty sure you need to get at them from behind, you might be able to push in the sides of the bezel to get them out, and the new ones back in, but I would be a little too worried about cracking the bezel. Might be worth a shot, be gentle though :) .
Hope this helps...
on my car the axle straps, and the drive shaft straps are the same size, we were gonna just paint and re-use the old ones, but figured while everything is out, might as well just replace them. If we can't find any localy then we probably will just use the old ones.
Thanks for the help,
-Chris
Quick question for you guys,
I've been ordering a TON of parts l8ly to redo the back half of the car, the ujoint straps I orderd from ecklers, part number 39841, which says they are for 63-96 vettes. Now they they have finally come my dad test fitted them and the holes don't line up? did...
Hey everyone,
Haven’t posted in a while since the vette has been running trouble free ::knock on wood::, but I thought since I got some new tires I would show them off a little bit :D I haven’t put many miles on the new tires yet but so far no rubbing (after doing the parking brake mod) and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.