Recent content by Raylicker

Update, after overhauling the heads, adjustable fuel pressure regulator and new MSD opti-spark it turn out to be the computer. I sent it to 4 places and finally the last said it was fried. Well after finding out it was impossible to find one I asked the last place what to do and they gave me the...

Was driving down the road when my 921 just quit on me. I smelt a little fuel . After about 20 minutes it started back up, I drove for about 3 minutes then stalled again. After 20 minutes it started again, but was almost home. I got a block away from home and it started to bog down again so I...

Yes I did and didn't help. What it was , was the IAC valve that I just installed in it was bad. My bad, it was a $15 part so replaced with one that was $90. Just goes to show you, don't by cheap parts. Still runs a little rough but just won an auction for a snap-on 2500 scanner so will finally...

Well I got it started but real high idle so did some spraying with starter fluid and think the intake is leaking, That was something I replaced during this whole thing and think I nay have screwed up the back sealant by trying to lay it down by myself, Anything else it might be? It also runs...

Well i tested at the fuel pump and have 44# but nothing showing at the Schrader valve, would the regulator do that?

Yeah I know I'll check that tomorrow. Yeah I replaced fuel pump and no gas out of FPR, heard it could be the relay

Well got it started, it was a f**king loose connector for the ignition control module, But anyway now I can only get it to run with starter fluid then it dies after about 45 seconds to a minute then it just dies. But thank you everyone for your help, but it just had to be something stupid like...

Please help!!!!!!!!

I replace connectors on grounds down on the block and on bell housing and still no spark. I don't know what to do. Could it be the computer?

This is a recap of my posting on another site {Thanks to everyone that help but still no start, so let me recap events(2 corvette was running but poorly so I decide to replace optispark with one from Cardone. At the same time I decide to replace intake, timing cover, oil pan and valve cover...

Could on of the sensors cause a no spark?

I tested with A VOM with ohms.

I did with a volt meter. Thank you, I hit a wall on this

Hey gmjunkie, I was told your the man to go to. Wondering if you have time to take a look at my post, it's under 92 corvette help forum. Thank you for taking a look before I take bullet in the head:r

Thank you, this has been going on over a month now and was just a two day project.