Recent content by Tomrw

JJ2k: Are you saying that if I have only one remote now, that may be the problem? I have had only one working remote for a couple of years, one quick working years ago. Not even sure where it is. When the second stopped working I replace the battery, resynced now it doesn't. Problem is I have to...

The second remote for my car has stop working, it will not reprogram using the lock-unlock 7 second hold. I replaced the battery. Reporgraming would hold for less than a day and had to be redone, now it won't reprogram at all. If I buy a new remote and I have found plenty of other threads on...

The method I used see link above on my last post to this thread. The fix lasted about one year the first time. I repeated the method after cleaning off the old RTV and it once again is holding. Tom

My power antenna has just stopped working; the antenna is almost all the way up. When I turn off the ignition I hear a clicking sound from the trunk and then it stops, but the antenna goes nowhere. Is it time to buy a new module? Any ideas where I can get a good price? Thank you for your...

24 hours

I have a very sucessful method see http://www.corvetteactioncenter.com/forums/c5-general-discussion/96188-conv-top-window-un-glued.html

I drove my vette one winter, and it handled very well in up to 8 inches of snow. Over 8 inches, I couldn't get any traction as too much snow piled up under the car and lifted the wheels off the ground.

I run 30 psi as recommended, using a dial type tire gauge. The cold pressure will vary based on the changes in outside temperature. 10 degree increase gives me about 1 to 2 psi increase on the pressure monitoring system.

I purchaes ti at the locat automotive supply store. I left the supports and tape in place for 24 hours, follow the direction on the tube. I used a very small bead of material, pressed it out using the top and then taped it.

Bonnell: I can tell you that my method using RTV has held since last September, good luck with the repair.

Just a quick up date, the window is still holding, not signs of letting go.

:w Columbia, MD here!

Purchaased my 2000 in September 2001 with 5,000 miles for $42K

Ok I made the repair in September, and it still holding. I used Permatex Item #81158 Silicone adhesive. Build a wooden frame to support the rear window from the inside. Frame has rubber in the vertical arms to help grip the window. The middle support piece has single nail at each vertical...

Mine is automatic with the HUD.