Search results

When I drive on the freeway on flat terrain, the best I have seen is 26-27 on cruise control at 75 mph on long trips. I have an A4 but what I think makes the difference is the 3.15 diff. However, when I check on my Normal day –to- day driving, I always see 18 mph on the DIC even if my daily...

I’m not sure if this is much different than on my 84, but here is what I do. 1- remove door panel 2- Remove the silver door cover that you see hanging on the picture. 3- Remove window. 4- Remove the 3 bolts holding the regulator at the bottom under the door. 5- Remove regulator.

... adding a picutre to your good description.... Circle in Purple is the Pump or BPMV (Brake Pressure Modulator Valve) and Pump Motor circle in Yellow is the EBTCM Circle in Green is the pump Ground Circle in Blue is the EBTCM connector

Is there any codes? These messages are the first thing you will see if any of the grounds or if any of the sensors, like wheel sensors or steering wheel position sensors is going bad. It could be as complex as the EBTCM module or as simple as a bad wire. I had that problem and it took me only...

Great !

You would need a scanner to enable the air pump and check few things to make a full diagnostic. However, due to corrosion and carbon built up the valve is the culprit most of the time. Check for any hoses and pipes for being connected, clamps secure on pipe and hoses, no kinks, hole or pinches...

Cool !

Thanks Patrick. I took a few minutes and created a new page for hand brake. I hope it will help. Do not hesitate to ask if you have specific question I did not covered. Go to http://pages.videotron.com/vette747/ and scroll down to the Hand Brake Link.

These codes are not related to hard to start. It should not crank for more than 3 seconds before it starts. I would start by checking fuel pressure. You should have 55-61 psi as soon you put the key to on. That could be a fuel pump going bad, therefore taking some more time to build up...

If you installed a new battery, that could be the red wire on the starter selenoid or the ground wire on the engine. Any codes? In case you want to check the other end of the cables: This is the proceedure to remove both cables, but just take the steps you need. Positive battery cable 1-...

X-Pipe. Not at all. Hoever, depending on the exhaust you can a some or more what we call 'Poping noise'. The X-pipe in some cases help or remove them. Warranty. I do not know.

^^^ I like that one. My Corsa My Friend's Borla

Actually the Borla was on my friend Z06. He never told me it was hotter, just Louder :L . I have Corsa on my car. I did not noticed more heat. The only time it came very hot in that area, that was du to the tranny on road race...

84 are great cars. Mine is 300,000 miles old on original crossfire engine.

Yep! The bottom of the rear fascia needs to be at 33 inches from the ground. I did it a few times. I have complete DIY on my web site. http://pages.videotron.com/vette747/ And scroll down to 'Borla cat back on Z06' this is for Borla, but this is the exact same thing as when I installed my...

Yes 195. I would not want to see 295. Sorry typo....

Looks like an advise from a pro that I want to listen to. Does 100,000 miles is high mileage?

Mobil 1 10-30 but I think I will go to 20-50 to increase oil pressure.

From my 97 service manual Fans have 2 speeds. Low and high speed. The PCM command low speed fans ON at 226 and OFF at 217 and high speed fans ON at 235 and OFF at 219. This is what you should see sitting the traffic. If you have AC on, fans starts. The thermostat set the temps when you...

I use the clear vinyl we put to protect the number & number plate on our motocross bike. It is made by N-Style. Go on their web site http://www.n-style.com/ click on enter Select SHOP N-STYLE Click on BACKGROUND Click on Background Sheet UNIVERSAL 12 X 17 BACKGROUND SHEETS (PACK OF 3) NBS0...