Search results

The original stereo was not that bad and quite nice looking in my oppinion. When 16 years old and not working it just forced itself through that a new stereo needed to be installed and to fill the hole and at the same time get som modern gadgets i installed a 2Din Pioneer with hard drive...

Thanks. With blower controll hole do you meen from the engine side? Where is the electric motor plug located under the dash, i have a vacuum bell all to the right in the foot well which i can see when removing lwer trim. Steve

My problem is that i am to optimistic :) When routing the wires i had to rout the iPod adapter to the glove box and the GPS arial up to the light sensor where i have it now. Was thinking that when i first did a job under the glove box why not rout the left front speaker wire the same way and try...

Thanks Paul, i have a look and if it is to bad a job i put it to profesionals. I might hav pulled the door from the vacuum valve when i routed new speakerwires that way :mad It was nice and warm before i did that job. Steve

pictures Anyone have som pictures of this operation. I am worried, hardly any room to work under the dasch.

I meen the page numbers not your pages :) Steve

Wow. Can you please give me the pages in the FSM. I been looking but get confused (not a tecnician);help Steve

I dont know, i do some investegation here first.

Easyest way to get to the air mix motor. I have vacuum working and the reason to my lack of het must be that the valve do not operate. Happened after i pulled some speaker wires through :mad thanks, Steve

Can i refasten the arm from under the glovebox or is this a major operation, It looks like the arm is off. Cruise works and it seam to be vacuum as normal. Steve

No codes showing, is it normal that the controll unit fails? Thinking by replacing that as a first step, just strange it happened after i put in a new stereo. Thanks, Steve

I tried this but cant see any movable parts, just that round thing vhere the vacuum line goes in. Which movement should i look for? Steve

Thanks John, i beleave this is on the driver side under the dash so i check it out. Steve

Hi. During install of a new stereo something went wron and i do not get hot air (it is hot but not as hot as before). Is there a way i can check that the air mix door operates? i might done something to it when pulling new speaker wires :-( Vacuum seams to be ok but it is kind of warmer in the...

How do i remove the right hand side kick panel. I can´t find any screws. Do i have to remove the glove box or is there any hidden screws somewhere? The left one was easy so i am a bit supprised. I need to take it off to come to the vacuum line and to line up a new speaker wire. it´s a 1993 by...

Thank you Rabbit. I guess it is similar on a 95. Steve

Hi. Have a problem with the heater and it might be the vacum. I installed a new stereo and after fiddeling under the dach the heating is very low. AC, fan and everything works but i do not have the heat as it used to be. I have a on/off leak under the passenger side fuel rail but it might be...

Thanks. I am going to check out this line. Will this vacum line be connected to the heat controll inside the car. Just in case i pulled it out somehow when fiddeling with the stereo. Regards, Steve

Any ideas? Where should i look? AC works, blower works, controller works. Just no hot air.

Replaced my stereo with a Pioneer 2 din navigation unit. Some fiddle and difficulties but it is in and working. The problem is that my heater wont work as it did. It produce warmish air but not as before. I did short the the lighter and blew the fuse for it but will this have anything to do with...