Search results

my 73 is the same way im 1/4 to 1/2 inch higher on passenger side.it still bothers me.

i have the same setup as makodrvr 1 1/8 in front 3/4 in back really helped the handling for my car.

http://davesrollingthunder.com/rt/rolling%20thunder/rear%20flares/Rear%20Flares%20Install.htm heres another good one too,im finishing up mine also.

what i did was change my crossmember in mine so i could run any size exuast i wanted past it.You can get them fron bowtie ,but i fabbed up one myself.

Nice 73,another new jersey guy.

im going threw the same thing right now,i got mine all glassed in ready for final sanding then paint.They look great on there good job.

sherry,its really not that bad to do,remove your 2 fuel lines and the 2 3/8 bolts holding it in place.The bolt inthe front of the block like you said install a long 3/8 bolt in that hole and hold the rod up to highest point and tighten bolt down just so it hold rod up(not too tight or youll...

nice car and i love the color:beer

accell 300 + race wires

i use kerosene also to heat a 14x28 garage,itll get up to 65 in half hour,also i buy there gallons of keroclean it burns cleaner and no smell,but $5 a gallon.But ill be switching to a propane wall mounted after christmas the ones they sell at lowes and home depot.A friend of mine has one for his...

Hey glen thanks,,i have a little bit of c4 and c5 into it.i too wanted the z06 rims but in a 4-5 inch backspace.not 6-7 like factory.I like a deep dish rim.

thanks,i love the electronblue,there made out of a bendable plastic so it bends to any shape.

heres mine- i have to recenter it this winter when i repaint it.there only held on with 2 sided tape . http://temp.corvetteforum.net/c3/patsvette/corvettes.jpg

robin as you lower the car, the tire will start to lean inwards so youll have to adjust the camber again.

dave is a member of the corvetteforum,ask him hell tell you where he got it from and whats involved.i have his email also i can ask him for you.

joliver how much do you get for it and any pictures of it.

actually we run on our c3's about 4 inch to 4.5 of backspacing on our cars that will fit without hitting trailing arm. the c5's are running some where in the 6-7 inch range,what that does is move the center of the rim to the far outside of it .Thats why the c4 and c5 rims are flat on the outside...

heres the z06 rims i chrome,i wish they made these deeper.

You would have to contact vette brake products and tell them what rims your going with and then they could tell you how far they will stick out if any.Also yes there not cheap.I think the ones your looking at the thin spoke c5 rims look good,then you have the earlier models thick spoke(wagon...

Did you check your turn signal flasher also,you have 2 flashers in the car.Swap the one with the other to see if they come on.