Search results

I'm not sure what was used at the factory, but I would think any good quality epoxy should work. :thumb

Do you have the optional hardtop? If so, install the hard top and adjust the door glasses to seal against the hardtop weatherstripping. Remove the hard top, raise the folding top, and adjust the weatherstripping on the folding top to seal against the door glasses. If you do not have the...

Correct. Correct. Correct. :thumb

Add Willcox and ZIP to your list. :)

Take the car to any automotive AC shop and let them check it. No sense replacing a compressor which may not be bad. :thumb

Post your VIN. Based on what you've said, it's going to be 1Z67J4S410xxx. Not sure what the "highway department" is telling you. Three more than what you posted earlier. The three missing numbers are indicated by the xxx above. Yes. 1 is the code for Corvette. 4 indicates the model year...

The stamp you see is a VIN derivitive and not a complete VIN. That explains why it is not showing up on the VIN decoder sites. You are also short three digits after the zero. Should be 14S410xxx. The J, T, and Z would be engine codes for the original engine installed in the car and would...

Would an 82 driveshaft work for you? :thumb

The convector is the final audio output. You need it to be able to hear audio through the speakers. :thumb

You don't have to try to find one now. :)

Yep. The 69 LT-1s are not a myth; there were two of them. Niether of these cars left St. Louis with LT-1 engines. The first was prepared by GM Tech Center in Michigan for the the long lead press review in the spring of 1969 to allow members of the automotive press to drive the car then have...

I have not used the Eckler's replacement bumper covers, but I agree with your body man. Your choice. :thumb

The C07 hardtop trim panels use the velcro fasteners and (IIRC, trim screws here and there) for attachment. These same type of velcro fasteners are used on door panels and t-top panels. If the trim panel is warped, the velcro fasteners will not hold well. For the applicable model years, the...

The trim kits have been available through the aftermarket providers for a while now. I've never purchased one. :thumb

Find and fix the rattle. Who installed your engine? Take them for a test drive and let them have a listen. :thumb

The stock 72 radio will fit your 69. Knobs may be different, but reproductions are available. You may want to consider a new center cluster bezel if Bubba boogered up your original. :thumb

I believe the owner's manual says three gallons in the tank when low fuel comes on. :thumb

You will need to remove the console side panels and the shifter plate in order to have access to the shifter. :thumb

Define "AC cut out". Can you determine what's missing? At the very least you need the heater/defroster core. :thumb

Automatic or 4 speed? Automatic shifters can be removed from inside the car with the exception of the shifter cable on the transmission. 4 speed shifters have to be removed from under the car. The assembly instruction manual (AIM) shows both installations. :thumb