Search results

Below is a picture of the motor mounts that were in my car when I pulled the motor. I’m not sure if they are factory correct or generic replacements. Anyone know? '63 340HP

Now that CAC is back up and running I can post some pictures of my progress with the engine rebuild. I’m just waiting on a few parts to button it up. The oil pump I ordered did not fit the stock oil pan so that’s on its way. Also, the ARP rocker arm studs did not allow enough clearance with the...

Looks like I am going to rebuild my AFB carburetor. Who do you recommend and how much will it cost?

How much should machine work cost? Deck the block (Its not the original block) Line Hone Mains Hone Cylinders Grind Crank – Mains and Rods

What clutch is everyone running? I’m thinking of the Centerforce Dual-Friction. Anyone have any feedback on this setup?

I’m looking to go with a new carb once I get my engine back together (see Dontov vs. 30-30 thread). I heard the Edelbrock Performer Manual Choke is a direct replacement for the AFB. Is this the best replacement? Will my current choke setup work with this carb? Also, will my PCV port plug into...

Well I’ll have the motor out tomorrow, and will have to decide what exactly I want to do with it. I might change the cam. I assume I have the Duntov 097 cam but I am not sure. When I have the cam out how will I know what it is? Are there numbers on it or will I have to have the profile measured...

Which way does the shifter come out on the ’63? Top or bottom? I’m pulling the motor and Muncie together. I just have to remove the shifter than I can lift it out.

I’m getting ready to pull the motor. I plan to pull the motor and transmission (4 speed) out in one shot. Does anyone know how much the motor and transmission weigh? Just want to make sure the engine hoist I rent will be within limits at full extension. Tim

I drained the Antifreeze tonight. It looks very rusty. Should this tell me something? Could it just be from sitting for long periods of time? Thanks for your help, Tim

Last winter I changed the rear main seal. I put the motor back together but I still see some oil on the garage floor. When I had it apart I took a picture of the rear main bearing. Can anyone tell me if the wear pattern looks bad? I am going to pull the motor soon due to some head work needed...

I’m looking to verify my engine components listed below. I have a 63 roadster which came with a 64 engine. My guess is that the block was replaced and all of the 63 components (heads, intake, etc.) were reused. I am planning on taking the motor out this winter to fix some of the problems with...