Search results

did you scrub the cylinders bores good with soap and water to get the honing grit out ???

like I posted before there is a "O" ring under that soft plug that is the seal. I have used fuel proof model pane dope for years with no come backs. gently tap around the edges to peen the area ,clean and use clear fuel proof model air plane dope for a fix the NCRS will never see.

if you use epoxy make sure it is ethanol safe.

the bore should be .375 and the shaft diameter should be .368

clean the area good and seal it with clear fuel proof model airplane dope. there is a O ring under that plug that goes away after years.

the new corvette engine uses a oil filter with the filter bypass valve built into the filter so there would some metal like a spring involved.

if you continue to fill the tank after the station pump shuts stop doing this as it is moving the slider into unused area causing the problem. I found this out with my 97. once I stopped force feeding the tank after the station pump shut off I had no more fuel gauge problem. I also has a...

correct the panels are painted by robots and the paint is like it is because of the federal air regulations about what these factories are allowed to put into the air

back in 66 when i tried to sell my 66 450 HP 427 corvette anyone who wanted to buy it the insurance payments a month were more than the car payments.

i understand the lower air flow under the C-7 required these extra coolers to help cool the trans and rear gear

the last good sales year was 2008 and what happened in 2008 a lot of peoples 401K took a big hit. as a corvette owner since 1959 corvettes are bought with fun money. my corvette club which has about 300 member and most of the new corvettes are owned by retirees like me who live off of their 401K...

I have the paper work for a factory delivered 396 vert vin 19467S114271

similar to diesel piston design which are DI except for the valve relief. THANK GOD for computer controlled machine tools

I believe that there was a TSB on C-6

corvette and HD have one thing in common, most red blooded males would love to have one

it will go a GM dealer only auction with a statement of the reason for the buy back. post the VIN here so no one else gets the car.

you can thank the EPA for it restriction on emissions from paint booths for your orange peel

after you have it repaired make sure you have 3M protective film installed on the mirrors. no matter what you hear here zaino will not prevent rock damage. :D

here is the GM heat shield and they also have one for the Q jet

there is a check valve in the fuel filter and if you use a filter without one the float bowl will drain down