Search results

Primer color Thanks Gerry The pic's help. Hadn't seen one stripped and sanded. Steve Weible

stripping paint Not sure yet but the two choices are the razor blade or a chemical stripper. I think the chemical stripper would be easier but since the fiberglass has some porosity I'm afraid some of the stripper may absorbed by the glass and would be a problem at a later date after the car...

I am considering stripping the paint off my 81 in preperation for a paint job. She was produced in Bowlimg Green 9/81 as a solid color car.  Does anyone know what color gelcoat and primer the factory used during that time period? There are two colors on her now, the original beige and a later...

I am considering stripping the paint off my 81 in preperation for a paint job. She was produced in Bowlimg Green 9/81 as a solid color car. Does anyone know what color gelcoat and primer the factory used during that time period? There are two colors on her now, the original beige and a later...

Thank you all. I will see what tests out this weekend.

I'm not sure which unit is't working. With the engine running the needle stays all the way to the left. How do I test the switch and gage?

My engine temperature gage quit working. I would like to replace the sensor in the block. Does any one know the original GM part number for this sensor. I am planning to try and cross reference the original number to find a sensor that will produce the same ohm signal so the reading is accurate...

Collant sensor Thanks for the help. I'll check it out.

Engine coolant gauge quit working. How do I test the gauge and the sensor?

Dave, Do you have a service manual? There is a good engine electrical diagnosis section. I had the same problem a few years ago, not on my vette but on my truck. The enging would just shut off. Some times it would start right up and sometimes it took several minuets. One day it stalled and...

What do I need to remove the rear shafts? The small bolts look like some sort of torx bolt. Where can I get a socket to remove them? I tried a E10 torx socket but it didn't fit well. I'm afraid of striping them and not being able to get them out.

I have had a battery drain for some time and have installed a cutoff switch to control it. It would be nice not to fix the problem so it's not a issue anymore. I connected a volt meter between the neg. post and cable then pulled all the fuses one at a time while watching the meter - no decrease...

Bud , I would like to order a long sleeve denim shirt in large. Please advise when they are being shipped. E-mail if you need my address.