A LUK clutch RepSet pressure plate and clutch were installed about 500 miles ago and pulled today. I pulled it because there was extreme judder when disengaging the clutch - had this symptom since mile 1. I believe the flywheel is original and it was resurfaced in a flywheel machine before the...
THought I'd share these pics. My Muncie is almost done. All gears are new except the reverse gears. New sliders and forks too. New tailhousing, bearing retainer, reverse shift shaft, new synchros, new bearings and small parts kit, new countershaft pin. If anyone want to rebuild their trans but...
purchased these heads for my project but couldn't use them as the seller took 3 months to ship! I-5-4 translates into September 5th 1964.
These heads have been completely rebuilt.
-Oven baked
-Steel shot blasted
-Magnfluxed
-New valve guides (cast iron...thick wall)
-CBN surfaced...
well not completely.... still needs paint, concrete sealant, final inspection, a 4 post lift, and a drop down staircase. Codes limited the peak of the roof to 17' so we had to get creative to fit a lift with enough room for a 3rd car underneath. My lot is too narrow for a three car and the...
dates are not important. Prefer a good rebuildable core or a rebuilt (not restored) carb. I'd liek to learn about holleys by taking one apart and putting it back together and then trying to tune it to run.
Thanks,
Brian
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.