Welcome to the Corvette Forums at the Corvette Action Center!

1986 Air conditioning compressor

  • Thread starter Thread starter bassman1986
  • Start date Start date
B

bassman1986

Guest
Does anyone know why the A/C compressor would kick on and off. It stays on for a
couple seconds and shuts off. Its a mystery to me. Thanks.
 
Compressor

My 2cents is that you are in need of additional R 12 or if you have converted add 134R, it sounds like you are hearing or seeing the compressor attempting to work but there is not enought coolent.
 
dr.wells2@sbcglobal.net said:
My 2cents is that you are in need of additional R 12 or if you have converted add 134R, it sounds like you are hearing or seeing the compressor attempting to work but there is not enought coolent.

YUP!
 
Yes, it certainly sounds like low refrigerant. Most common place for a leak is the shaft seal on the compressor. If this is the original a/c, be advised that all a/c systems leak over extended periods of time (in my experience), especially if you don't use it, that's why you should run the a/c a few times a month even in cold climates to keep the seals from drying out.

If you're handy, it's a fairly straightforward process to fix the a/c, again I'm guessing it's the compressor that's leaking, you'll need a new one, as well as a new accumulator. If this is the original refrigerant (R12), those should be the only things you need, and once they're installed you can flush, pull a vacuum to -29 and re-charge with R12. If you want to retrofit to the new R134a, it's a perfect time to do it (if it hasn't been already), you'll need R134a-compatible o-rings too.

There are lots of helpful a/c people at this forum, why not visit:

http://www.aircondition.com/wwwboard/

also this is a great site:

http://www.diynet.com/diy/ab_auto_air_conditioning/article/0,2021,DIY_13674_2276708,00.html

If you are handy with tools and can follow directions, there is no reason to pay through the nose for a new a/c system from a mechanic. The number one tool you will need is a set of manifold pressure gauges, which you can buy off ebay for $40, and this will tell you the high and low pressures of the system. Secondly you'll need to buy or rent a vacuum pump.
 
Most GM a/c systems have a pressure switch in them which turns off the power to the compressor if the pressure on the low side get to low. The reason for this is to protect the compressor. Each time the compressor runs it lowers the presure on the low side of the system turning the compressor off. Once the compressor quits the pressure comes back up and resets the switch so the compressor runs again. This will continue till the system is so low that the switch stays open. It is advisable to not run they system this way because the compessor may starv for oil and ruin it. The refrigerent carries the oil so when the system is low oil may not get back to the compressor.
 
bassman1986 said:
Does anyone know why the A/C compressor would kick on and off. It stays on for a
couple seconds and shuts off. Its a mystery to me. Thanks.
Turn it off and keep it off until you can get it serviced. From experience, I know that turning it on and wishing it to work will ultimately fry the compressor. I believe the coolant is low and that's giving a false read and wigs out the pressure switch. Not a bad idea to check your hoses for leaks and wiring for bad connections.
:v
 
It's "short cycling" due to a low charge. Finding a leak can sometimes be harder then finding a hooker in a monastary. Have a pro (mehanic kind) look at it.


Len:)
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom