Help! 1993 door moulding installation.

[FDZ]

I have to replace the drivers door exterior moulding. Anyone know the correct method of going at it?

FDZ

 

[Rabbit]

There's a nut on each end of the molding (inside of door).

After removing the nuts there are 5 clips that you have to carefully remove from the ends.

Install is the reverse.

 

[FDZ]

There's a nut on each end of the molding (inside of door).

After removing the nuts there are 5 clips that you have to carefully remove from the ends.

Install is the reverse


Thank you for the instructions. I see the 5 clips which hold the moulding firmly to the door. Do you have to pop them out from inside the door or just slide the moulding to the rear leaving the clips in the door?

Best regards

Frank

 

[Rabbit]

There's a nut on each end of the molding (inside of door).

After removing the nuts there are 5 clips that you have to carefully remove from the ends.

Install is the reverse


Thank you for the instructions. I see the 5 clips which hold the moulding firmly to the door. Do you have to pop them out from inside the door or just slide the moulding to the rear leaving the clips in the door?

Best regards

Frank

According to the FSM they are pulled out by grabbing the molding at each fastener location. That's how I took one of mine off.

 

[FDZ]

According to the FSM they are pulled out by grabbing the molding at each fastener location. That's how I took one of mine off.

Thank you I will give it a go.

Frank