Help! '94 Window Motor Test?

[Donne Trav]

[TABLE="class: tborder, width: 100%, align: center"]
[TR]
[TD="class: alt1, bgcolor: #F5F5F5"]Is it necessary to remove "window relay" to test motor? Window switch was been tested — found to be bad —and replaced — drivers side window still not working? Thanks
[/TD]
[/TR]
[/TABLE]

 

[ecss]

Here's a schematic for a 95. 94 should be the same but the color of the wires could
be different.

The window control module provides either 12 volts or ground to one lead of the power
window motor. It can also automatically roll the window down after you have released the switch.

 

[vetteoz]

[TABLE="class: tborder, width: 100%, align: center"]
[TR]
[TD="class: alt1, bgcolor: #F5F5F5"]drivers side window still not working?
[/TD]
[/TR]
[/TABLE]

:eyerole

As I have already told you on other forums about this window problem
Unplug the window motor connector in the door.
Put 12V to one terminal of the connector and ground to the other.
Window should operate.

Reversing the polarity it should go in the opposite direction