abs light on

[kohlbear]

All wheel sensors cleaned and checked at 1000 ohms. Wires appear tight in control module area. Anything to do, other than go to the dealer?

 

[JrdnsEdu]

do what my wife does.... put a piece of electrical tape over it so you can't see it and the problem magically goes away.

 

[kohlbear]

That's the best idea I've heard yet!

 

[KOPBET]

do what my wife does.... put a piece of electrical tape over it so you can't see it and the problem magically goes away.

Since we don't know what vette we're talking about, that is probably the most logical answer!

 

[kohlbear]

Its a 87 z52 Coupe!

 

[kohlbear]

Do you think a sticking caliper could cause the abs light to stay on?

 

[KOPBET]

Don't know much about an 87 so I can't really say. I doubt it though. On later model cars you would also need to read the DTC codes, if any, from the CCM. I don't know if an 87 even HAS a CCM.

 

[LT1-MP]

Mine did that only when I was driving it hard. The "Service ASR" light would also come on. Topping-off the brake fluid fixed everything. I didn't think of it at first 'cause the level "looked" fine. Good luck!