N
nd4speed
Guest
Hi, need some help here. going to look at a 76 tonight. priced right i think. can someone tell me how to check for rust in birdcage area. thanks, john
Even though it's a C2, this chapter http://www.computersupport.ca/Restoration/PaintRemoval.htm
and the one following it should help you.
and the one following it should help you.
- Thread starter
- #3
E
Enigma
Guest
The easy areas to look at are the 2 cowl vent covers. They are held in place with 1 philips head screw. When uncovered you will see the forward support posts of the birdcage. If there is a lot of rust here , I'd walk away.
The other area which is a bit more difficult, is the access cover to the rear part of the birdcage. You'll need to remove the back wheels. Then you'll see an access panel held on by 4 screws.
Remove this panel and with a flashlight look inside. Again if there is a lot of rust, walk away unless you plan to do a frame off.
Another trick is to slide a business card under the windshield molding and see if any rust drops out.
Good Luck
Enigma
The other area which is a bit more difficult, is the access cover to the rear part of the birdcage. You'll need to remove the back wheels. Then you'll see an access panel held on by 4 screws.
Remove this panel and with a flashlight look inside. Again if there is a lot of rust, walk away unless you plan to do a frame off.
Another trick is to slide a business card under the windshield molding and see if any rust drops out.
Good Luck
Enigma
- Thread starter
- #4
N
nd4speed
Guest
i looked at the car today. not sure what to think. interior weas trashed. sagging rear end. recently painted ? not very well. wet spots underneath. frame seemed solid although i did see a few fixes in floorpan. is this what i can expect for under 5000?
Similar threads
Corvette Forums
Supporting Vendors
Dealers:
