Calling 1967 Heaven

[kev]

Where did you get your hammer bit to install the body rivets?
Thanks

 

[Mac]

[FONT=Century Gothic, Arial, Helvetica]According to his website, the tool is a concave end by Chicago Pneumatic #A046089 (Set-Rivet.25RD.401SH). Are you looking for the name of the supplier or is the name/part number enough for you?

-Mac
[/FONT]

 

[kev]

Thanks Mac I need the name of the supplier. I have looked all over the place for the rivet bit :W.
Kev

 

[XLR8]

I wonder if Stepinwolf would know? I was going to send him a PM but he has the PM feature turned off.
Maybe JohnZ? Tom Bryant? Viet Nam Vett? Kid Again?

Jane Ann

 

[Yoda]

Take a look Here and see if this is what you are looking for ..

Bud

 

[robert64]

I ordered mine through Aircraft tool supply. 0470-3-3/16" rivetset offset 10 degrees. About $20.00. www.aircraft-tool.com Regards, Robert.

 

[kev]

Thank you I'm going to order one. What is the 10 degree offset all about?

 

[LittleRedFlatBack]

Not to hijack this thread :hijackbut you did ask the question. Where is Bob (67Heaven). Haven't seen him post in a while. Hopefully the weather is going his way and he's just busy with the new garage.hnoes

Dennis

 

[Mac]

Where is Bob (67Heaven).

67 is tied up in a big project. He'll be back soon...

-Mac