Welcome to the Corvette Forums at the Corvette Action Center!

Clutch Pedal Rod Boot

a69vette

Well-known member
Joined
Jun 20, 2001
Messages
264
Location
Valrico, Fl.
Corvette
1969 Triple Black Convertible: 2014 Crys Red Conv
Just slides on over the clutch pedal pushrod and attaches with three screws (after removing the adjuster swivel and nuts, then replace them when you're done and touch up the clutch adjustment); takes about ten minutes.
:beer
 
Easy install. Just put one on my 70 before putting the engine back in. Like said above, three bolts hold the boot to the firewall. At the end of the clutch rod is a nut that you need to take the nut off of, slide the clutch rod out of its holder and slip the boot on. You may want to put some lube on the lip of the boot to help it slip up the clutch pushrod easier. Piece of cake.
 
Great! Thanks. I was looking for the source of my heat, I think I found it.
Thanks again.
Rick
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom