Welcome to the Corvette Forums at the Corvette Action Center!

First Dyno Run

02VetteCoupe

Well-known member
Joined
Jan 1, 2011
Messages
52
Location
va beach
Corvette
2002 Red Coupe (Intake/Exhaust)
I just did my first Dyno run. She has 75k miles and just pulled a baseline 289.7 at the wheels. Before any tuning. She was running a little lean. This is with an Aftermarket exhaust and intake... x pipe and back anyways... I'll post my final numbers when I get them... anyone else have some baseline numbers to compare with?

Also I have run a 12.9 with her and that was before new tires
 
I'm not sure. I can't see any name on the exhaust. And I will have to check the intake... I just Dyno tuned her. Now she's running with 314.5 hp and 320 lb/ft (up from about 280ish) you can feel the extra power for sure, especially top end. But I ran the 12.9 with old tires and the old 289.7 hp with 40 less pounds of torque, so I plan on running a 12.5 next time. The tires made an obvious difference. No more spinning through slamming second, she just squats and runs now. I wouldn't think the exhaust is a low end brand because I just bought the same Michelin pilot sport a s plus ZP that were on it and cost around 1500 total for everything including warranty. If they paid that for tires I don't see them cheaping out on oil changes or smaller upgrades. I would assume since they bought the best tires then whoever had her before me took awesome care of her in every way.
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom