ed moss
New member
took my 96 collectors edtition for a first ride after installing 410 gears. now it has a vibration between 55 and 70mph in 5th or 6th gears. never noticed it before .is this normal
first post vibration since 4.10 install
- Thread starter ed moss
- Start date
- Thread starter
- #2
ed moss
New member
vibration since 4.10 install
took my 96 collectors edtition for a first ride after installing 410 gears. now it has a vibration between 55 and 70mph in 5th or 6th gears. never noticed it before .is this normal since every thing in drive train is sping faster. I did mark all shafts and yokes and reinstalled them the same way.Makes no noise or whine
took my 96 collectors edtition for a first ride after installing 410 gears. now it has a vibration between 55 and 70mph in 5th or 6th gears. never noticed it before .is this normal since every thing in drive train is sping faster. I did mark all shafts and yokes and reinstalled them the same way.Makes no noise or whine
Ken
Gone but not forgotten
Normal? No.
Was anything else changed such as u-joints, bearings, wheels, tires, etc.? Did you have the driveshaft balanced?
Was anything else changed such as u-joints, bearings, wheels, tires, etc.? Did you have the driveshaft balanced?
- Thread starter
- #4
ed moss
New member
Vibration since 4.10 install
No nothing else was changed at that time. Since then I took it all apart again inspected, replaced ujoints sent drive shaft out to be balanced. Thay said it was perfect, disassembled the rear and found nothing wrong, good even wear pattern on ring gear all bearings good. I have not put it back together yet waiting for half joints replacing them while its apart. Somthing I noticed were the batwing mounts to the frame the bolt holes are sloted could this be a wheel alignment problem, the right rear wheel did have a positive camber angle that I could see by eye
No nothing else was changed at that time. Since then I took it all apart again inspected, replaced ujoints sent drive shaft out to be balanced. Thay said it was perfect, disassembled the rear and found nothing wrong, good even wear pattern on ring gear all bearings good. I have not put it back together yet waiting for half joints replacing them while its apart. Somthing I noticed were the batwing mounts to the frame the bolt holes are sloted could this be a wheel alignment problem, the right rear wheel did have a positive camber angle that I could see by eye
Similar threads
Corvette Forums
Supporting Vendors
Dealers:
