Im calling Extrude Hone tomorrow.

[SurfnSun]

Im going to talk to them about extruding my Edelbrock base manifold. I want to find out how fast they can get it done. I think Im going to go ahead and bite the bullet to have this done. I'll probably wait until I get the bill from Callaway to make sure I dont' run across any unexpected costs.

Maybe Chris should be writing an article on my buildup for one of the Corvette mags out there so I can get some project sponsors to help off set the cost

Max Boost B2k. By CC.

Works for me

 

[*89x2*]

Josh, I know another B2K will be featured in an upcoming issue of Corvette Enthusiast Magazine as some other Callaway Related articles -

project sponsors, I love it

p.s. 'bout time you called Extrude Hone

 

[SurfnSun]

p.s. 'bout time you called Extrude Hone

I need an IOU.

 

[SurfnSun]

Called today. The guy I spoke said the amount of material removed was between .030-.050 and that flow would increase approx 20%...but he was out in the shop and didn't have any specific #'s.

Bad thing other than the cost is at least 3 week turnaround. Hmmmmmm

 

[*89x2*]

Have patience Josh, you have seen what the flow #'s equate to in power