Welcome to the Corvette Forums at the Corvette Action Center!

Intake and hood clearance

tomgok

Active member
Joined
May 6, 2013
Messages
40
Location
ok
Corvette
76 L-48,coupe
20160327_172935_resized.jpg20160325_154236_resized.jpgJust installed an Edelbrock #2101 intake on my 76 C3. With the stock Q jet and air cleaner I had sufficient hood clearance. About a 1/2 in on the front edge. :thumb
 
It looks like your distributior is one tooth off, 1 and 8 towers should be even
Is that an aftermarket PCV valve? The wrong one will affect your idle quality
Are you running your vacuum advance ported or Manifold?

Sent from my SM-T530NU using Tapatalk
 
Nice looking engine. I wish I could keep mine that clean but living in the mountains with one mile of a dirt road leading in and out it's impossible to keep mine clean.
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom