Welcome to the Corvette Forums at the Corvette Action Center!

Intermittint Starting

R

Robert G Taplin

Guest
89 Conv. auto, turn key all dash function,air, radio,gauges but staster does not engage or turn. Remove key wait 2 min. try again and the car will start, some times up to 10 min. wait then car will be fine for days.Car is now at Chev Dealer and they don't have a clue. Ignition switch with new keys doesn't help.Anyone have any ideas? Thanks
 
I do

Assuming that there is not power at the starter (this has nothing to do with lights, dash illumination, a/c etc.....)
Tell you mechanics errrr...to look at the VATS control module.
Very common in 89 and 90 Y cars and F cars.
Waiting a few minutes is the timeout for a wrong code. VATS will do this, when it does not recognize the key code.
 
I hate VATS!

Ok here's the deal, The little pellet on the key is nothing more than a presicion resistor. There are two little fingers internal of the key switch that sence the resistor. If the fingers are weak or corroded the resistor value gets higher than spec and the VATS thinks the owner is stealing the car.
( Nice feature huh?) ( or if the key itself in gunky)

Now you stated that you put in a new key switch & a new key didnt help.

Which leaves the following question, Did the dealer
replace Just the switch ( using the existing wiring by soldering on the new switch) or replace the whole switch & wiring down to under the dash?

A quick Fix ( for the brave at heart)
Remove the cover panel under the dash
find the 2 pin connector ( Small white wires, black jacket, brown connector right side of steering collum)

Get a buddy with a GOOD ohm meter, measure the resistor value on the key itself

Go to radio shack, buy matching resistor

remove connector under dash and solder the resistor across the wires that are NOT on the steering collum side but VATS side

Leave connector unplugged

Start car... see if that fixes your intermittant problem.

If it does your wiring up to the switch is bad.

If it dosen't your VATS module has a corroded connector OR is going bad.

Hope this helps

Vigman
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom