Welcome to the Corvette Forums at the Corvette Action Center!

Jeal cold air intake??

JT ZR-Won

Well-known member
Joined
Dec 6, 2000
Messages
1,292
Location
Bradenton, FL
Corvette
'90 ZR-1 #3010
Does anyone have any info on the Jeal carbon fiber cold air intake? I have seen this on a few ZR's before and I am really thing about getting one because I need to get another accordian hose for my intake but am having trouble locating one.......and the Jeal unit goes all the way up to the air horn. Sweet setup:)

Jay
 
Jay,
Don't know too much about the Jeal carbon fiber cold air intake, but here's some info you might find of use. :s

Jeal & Sons
Europes only ZR1 Specialist
Unit A1, Heath Farm.
Swerford
Oxfordshire
England
Phone01144,1608,737701
Fax 01144,1865,844899
email - Geoff Jeal 101621.3447@Compuserve.com
 
Jeal's air filter box certainly looks neat and, as it's made of carbon fiber, it's light as a feather. But, the short intake duct that comes with it, misses the mark, IMO. I've seen the Jeal box on other cars and when the underhood is at operating temp, the rubber/plastic or whatever it's made of kind of sags down into the air flow.

I had considered putting a Jeal air filter assembly on Vette's "Purple Project" car and, in preparation for that, ran some dyno tests with the stock air filter box modifed with a K&N Filter and a DRM open-element top connected to a stock duct vs. no filter or duct at all and there was no change in performance between the two. That means to me that the addition of the Jeal airbox would not affect performance IF we assume that performance with an air filter assembly could not be better than no airbox or duct at all. After that test, I decided I didn't want to go to the trouble to cut the hole(s) necessary to mount the Jeal box.

Now, the Jeal air filter box is one of those that takes air from the cooling intake. My test did not take into account any performance increase via the ram air affect that might come into play once the car's speed gets over 100 mph or so.

As for air ducts, rather than forking out money to buy an aftermarket air duct, I performed a trick I've seen on a couple of cars owned by resourceful Zroners. I made a small, steamlined, aluminum brace and screwed it inside the stock air duct. With that brace there's no potential at all for the duct collapsing and my dyno tests show inserting the brace has no affect on performance.
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom