J
jpanek
Guest
I'm going to take a look at a 1994, 86K miles, AT, and want to do a few diagnostics, but don't know the engine layout too well. Any help is much appreciated:
1) Where is a good spot on the intake to measure manifold vacuum?
2) How easy is it to disconnect the ignition coil from the optispark and short the spark to ground? I want to crank the motor for 5-10 seconds while watching starter motor current draw on a high resolution oscilloscope. This will show pulses during the compression strokes and reveal a poorly sealing cylinder.
3) The opti has been replaced at 80K. How can I tell if it is the new vented style?
4) I've got the CAC.com checklist and the c4vettes.com cold start checklist. Good stuff! Anything else I could look for as far as checking engine condition?
Wish me luck!!!!!!!
1) Where is a good spot on the intake to measure manifold vacuum?
2) How easy is it to disconnect the ignition coil from the optispark and short the spark to ground? I want to crank the motor for 5-10 seconds while watching starter motor current draw on a high resolution oscilloscope. This will show pulses during the compression strokes and reveal a poorly sealing cylinder.
3) The opti has been replaced at 80K. How can I tell if it is the new vented style?
4) I've got the CAC.com checklist and the c4vettes.com cold start checklist. Good stuff! Anything else I could look for as far as checking engine condition?
Wish me luck!!!!!!!



