Oil Pan Replacement

[wrc3]

I was looking for a pan to replace my old and busted one. Any suggestions? I have seen a few postings on the Mildons, but no part numbers are listed. What about the Aluminum ones from Summit?

http://store.summitracing.com/default.asp?target=eadvsearch.asp&SearchType=Make

Basically looking to see if anyone knows of fitment issues before I order.

Thanks

B

 

[JohnZ]

The key fitment issue is to measure the front seal radius before you buy gaskets so you know whether it takes the "thin" (0.22") or the "thick" (0.41") front seal.

Flip the pan upside-down on a flat surface with no gasket, and measure up to the 12 o'clock position on the pan's front seal surface; if it's 2-1/4", it takes the "thin" seal - if it's 2-3/8", it takes the "thick" seal.