Power Soft Top

[olddog58vette]

Where do you check the hydraulic fluid on a power soft top for a C-1. :W THANKS.

 

[cbernhardt]

Taken from the pages of the ST-12:

Proper fluid level must be maintained in the hydraulic system to insure proper operation of the top mechanism

• Operate the top to its raised position.
• Disconnect the positive battery cable.
• Remove the fiber panel shielding the top mechanism in the rear compartment.
• Place absorbent rags below the pump reservoir at the filler plug (right hand end).
• Remove the filler plug. Fluid level should be at the bottom of the filler plug hole.
• If fluid is low, add hydraulic fluid (G.M. Hydraulic Brake Fluid Super No.11 or equivalent) to bring up to bottom of filler plug hole.
• Install filler plug, shielding panel and battery cable

Charles