power steering hose piping

[IH2LOSE]

I am building a custom 62 vette that uses the suspention from a C4 vette.I have the rack in and I am trying to pipe the power steering hoses in.And I am trying to confirm what hose goes where

From this picture

Can some one take a look at there car and confirm where the hose goes from the port I have my finger on.

and then tell me where the other port on the rack hose is connected to

thanks

Larry

 

[JonM]

Goes to the closest to the drivers side of the reservoir. Because their is no real pressure, it is held on with clamps...if need be I'll take a pic.

 

[IH2LOSE]

Thanks a million.I dont know what I would ever do with out this forum and its very generous users who take the time to help a fellow corvetter out,regaurdless of the generation of car.

I had my hoses reversed. the port with my finger on it was going to the pressure side of the pump.From your picture with the outlining you did I now know.

Port with my finger goes to the resivour. from the resivour the big hose goes to the suction side of the pump ,then from the pressure side of the pump Into the the pressure side of the rack.(the port my finger is not pointing to ) Does this sound correct.

Thanks Again

 

[JonM]

Does this sound correct.

Thanks Again

Sounds good...