Welcome to the Corvette Forums at the Corvette Action Center!

Sport Seat Upgrade

  • Thread starter Thread starter tcramstrek
  • Start date Start date
T

tcramstrek

Guest
I recently upgraded my 91 from factory seats to electric Lumbar Control Sport Seats. I mounted them directly to the six way power track and now I would like to connect the wire harness for the lumbar pump motor. I received the Factory harness with the new seats! ( The New Sport seats were also removed from a 91) How Does this hook up to the power and ground ? should there be a connector already in the chasis harness pre wired from the six way switchs? Is it in the vicinity of the control switches under the console, or does it get its own seperate power and ground source from the main buss? My shop manual does not show this illustration of detail very clearly...
 
my 89 has a seperate husky 2 wire (1 hot 1 ground) plug that comes out of the floor with the six wire (track control) plug that is hot all the time.

tcramstrek said:
I recently upgraded my 91 from factory seats to electric Lumbar Control Sport Seats. I mounted them directly to the six way power track and now I would like to connect the wire harness for the lumbar pump motor. I received the Factory harness with the new seats! ( The New Sport seats were also removed from a 91) How Does this hook up to the power and ground ? should there be a connector already in the chasis harness pre wired from the six way switchs? Is it in the vicinity of the control switches under the console, or does it get its own seperate power and ground source from the main buss? My shop manual does not show this illustration of detail very clearly...
 
Since I am installing this "husky two wire harness" do you happen to know how it is suppose to be routed / "under the console ?" maybe /, is there a conduit or specific place of some sort?
 
I'm sorry I don't... I think it goes to the outside edge and goes up the door sill (the part of the frame you step over to get in) and comes out under the dash. I don't think there are heavy enough wires that run down the center through the console (had that apart when I changed transmissions).
 
Did you figure out how to run the power? I replaced my standard power seat with 2 sport seats and continue to be stumped on the wiring! Any help you can provide is appreciated.

Jeff
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom