Tow point C6 2005

[gshultz5]

Dumb question I'm sure. Dose anyone know where the tow point is for my 2005 C6

 

[kpic]

IMO, a flat bed.

 

[vett boy]

Dumb question I'm sure. Dose anyone know where the tow point is for my 2005 C6

Not a dumb question . I actually don't believe there is one (sorry) .There are 4 tie down and jack points on the frame but that's it .Best wishes

 

[gshultz5]

Not a dumb question . I actually don't believe there is one (sorry) .There are 4 tie down and jack points on the frame but that's it .Best wishes

First I have non flats. But, if I was to be towed onto a flatbed where should I be looking for the driver to attach to from my car? Most likely the tow driver will have no idea.

 

[kpic]

Make absolutely certain you tell the towing company it is a Corvette.

 

[Stutterfly]

Flat Bed Upload

Hi this issue has happened to me twice
1st time flat bed arrived , the driver slid a hook and chain under the front
I enquired what was he attaching the hook to he said the front sub frame
well like others you tend to rely on people doing there job properly
so on the way to the garage I asked him questions he said they don't get
a lot of vet pickups but they wanted to get the job done as quickly as
possible I got the impression !!
arrived at garage of loaded car put on ramp I had a chance to inspect
the underneath no visible damage hook was on front sub frame but
there are rubber bushing there that if distorted may affect the handling
so I thought there must be a easier way if this happened again and it did.
2nd time flatbed arrived I said do you have any hooks and rope he said yes
we keep all manor of stuff so this is what I want take a hook one side. rope attached
and insert into the 1st puck hole I did the other side perfect, car loaded all fine
get to the garage put on lift checked underneath no damage to puck holes.

so long story but effective

2007 1lt non run flats, the issues above were not tire related.

 

[Backinsaddle]

I had a failure of my cable on the auto transmission and called OnStar who dispatched a nit-wit who hooked it up wrong destroying the air dams on the front......OnStar replaced them and paid the labor to install the new ones......wish I knew where to hook it up for a roll back tow.....I would "help" them get it loaded......