Question: Tool dimensions

[Trlloyd]

In my service manual for a 74 Corvette, there is a tool used to keep the lower control arm from bending when pressing out the bushings. It is basically a pipe with a slot cut in it to allow a tech to put it between the bushings and over the A arm control shaft.

Does anyone have those dimensions?

Thanks

 

[frank_nesta]

In my service manual for a 74 Corvette, there is a tool used to keep the lower control arm from bending when pressing out the bushings. It is basically a pipe with a slot cut in it to allow a tech to put it between the bushings and over the A arm control shaft.

Does anyone have those dimensions?

Thanks

Most shops support the control arm on a vice and air hammer the bushing out.