Antz81
Well-known member
Any advice here would be appreciated.
I've been trying to track down the source of a rough idle problem. I've fixed a few vacuum leaks and am in the process of fixing the last one(I hope). However I did make one odd observation about the dwell readings on my mix solenoid. Everyone else reports a low dwell when they have vacumm leaks but mine is at 60deg (even before I started to fix any leaks).
today I noticed that my idle mixture settings on the carb appear to have been altered. could this be the cause of my high dwell? If so should I just return them to factory settings or should I have a much deeper look into things?
it has also been getting harder to start from cold with each leak that I have fixed.
I've been trying to track down the source of a rough idle problem. I've fixed a few vacuum leaks and am in the process of fixing the last one(I hope). However I did make one odd observation about the dwell readings on my mix solenoid. Everyone else reports a low dwell when they have vacumm leaks but mine is at 60deg (even before I started to fix any leaks).
today I noticed that my idle mixture settings on the carb appear to have been altered. could this be the cause of my high dwell? If so should I just return them to factory settings or should I have a much deeper look into things?
it has also been getting harder to start from cold with each leak that I have fixed.