Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by CHERRYPICKER

  1. C

    93 Headlight woes

    well the JB weld seems to work. headlight is going up and down ( like it should ) took a look at the drivers side and it has a newer gasket on the motor so i will assume it has been rebuilt before...not gonna touch it...lol thanks for the help guys cheers Glenn
  2. C

    93 Headlight woes

    Thanks Rex bronze and plastic gears are available, but i think they are just the ones that mesh with the worm gear, this piece does not mesh with the worm gear. On some advice from a mechanic friend i have tried liquid weld. we shall see if that works tomorrow. Glenn
  3. C

    93 Headlight woes

    Hello to all, slight problem with headlights.... passenger side is lazy... bought pellets for both sides opened up motor and original pellets were fine further investigation found stripped shaft and wheel ( for lack or a better word ) pic: questions; can this/these parts be purchased...
  4. C

    Thanks Junk!

    WOW....just north of Canada ???? you in Russia? lol
  5. C

    Question: emmisions help

    Hey Schrade.. nothing new to report, ive either been to busy or its been raining like crazy to get the car in for another air test. thanks for the thought though...lol will let ya know as soon as i do cheers Glenn
  6. C

    Greed, not unions, brought GM down

    Organizing Burger King sounds like a good plan. The burgers might be a little more expensive, but if layed off auto workers get working there the the darn burger will go 0-100 in 3.5 secs. just my thoughts
  7. C

    Question: emmisions help

    UNCLEBILL: Welland eh? 10 minutes away, im in St.Catharines. could be a few days before i take it in again...i hope its blowing better now than before. I'm gonna make sure its good and hot this time, get the cats nice and toasty.
  8. C

    Greed, not unions, brought GM down

    As a CAW member for the last 32 years ( retiring on July 1 2009 ) i can say that General Motors has paid me a decent wage for the job i have done for them over the years. Years ago the union was a much needed entity, wages were low, working conditions were poor, and human rights were violated...
  9. C

    Question: emmisions help

    Injectors are installed. took about 2 hours, not really a hard job. ordered the Bosch III flow matched from FIC a little different installation: injectors into the intake first, don't re-use the clips. First install: one was leaking because it didn't seat into the fuel rail properly. Re-seated...
  10. C

    Question: emmisions help

    Forgot to add For some strange reason up here in the north, if your car does not pass emissions, and the cost to fix it is estimated at MORE than $450.00, then they give you a "conditional pass" which allows you to plate the car for 2 more years. ya cant sell it, but you can plate it. All this...
  11. C

    Question: emmisions help

    Thanks for all the great info guys, it is much appreciated New injectors ordered today, will install when they arrive and expecting neck snapping results. lol cheers Glenn
  12. C

    Question: emmisions help

    Scrade: ive read that post....it didnt seem to apply to me....have no idea what EVERCLEAR is , and we dont have any ABC stores here. I really dont want to add anything into the gas tank as that will foul up the injectors worse than they are now....if thats where the EVERCLEAR goes...lol gonna...
  13. C

    Question: emmisions help

    Thanks for the reply's guys... c4c5: i think im going to change all the injectors, these might be the originals and its probably about time. As far as i can tell ( its really the first time under the hood of this car) there is no Plenum or runners to remove, just the fuel rails...is this...
  14. C

    Question: emmisions help

    Hi all, new member from Canada 93 LT1 , trip black convert, 120 k miles Have been reading some excellent stuff on this site, you guys are unreal. Bought this car out of Vegas 2 years ago, passed safety and emissions here after a couple of lights were changed and the daytime running lights were...
Back
Top Bottom