After much cursing and stretching I was able to get the clip off the push rod using a 3/4 wide chisel which worked better then a plain flat blade screwdriver. To remove the clutch master cylinder I did have to remove the car battery for access to the inner cylinder mounting bolt. Installing the...
There must be some special way to access the push rod of the clutch master cylinder under the dash, so far I have used a remote lighted camera on a flexible arm, a lighted mirror on an arm and I can always visually locate the push rod clip but am unable to use a long screwdriver to contact the...
What is the secret to accessing the spring clip on the push rod under the dash. I dropped the hush panel and access to the push rod attachment to the clutch pedal is almost impossible. The clip must be removed before the clutch master cylinder push rod and the master cylinder can be removed. It...
I had the transmission fluid levels checked and topped within the last 200 miles however I printed out from the GM service manual the Std and OD trans filler plugs diagram page since my car is older then the mechanics that serviced it. I'm sure they didn't drain and refill the OD unit in fact...
OD shifting
I noticed in my '88 Vette that on occasion when in OD there is momentary power slippage similar to a slipping clutch. However when I'm not in OD my car runs normal with full power, no slippage.
Is the OD "slippage" something that can be corrected adjusting the TV cable? My Vette...
A further electrical check of the fuel delivery "system" showed that the installed pump was not running. I pulled the pump and installed a new Bosch elect. pump and now the car is running fine.
I believe that the water in the fuel was the ultimate cause. I had siphoned the old gas and removed...
New follow up to "fuel pump not running, C4 won't start". I had just replaced the fuel pump relay, I reinspected all the connections at the fuel tank and I then bridged the connection with a jumper wire at the OBD unit under the dash, connecting A to G and ... nothing.
I now have a new Bosch...
Thanks for your insight, all the relevant fuses checked out. To recap the no starting problem:
1. Car was running OK with a code 36 (MAF indication).
2. I cleaned the MAF with CRC, OBD code read 12. Car then wanted to fire up strong but wouldn"t run...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.