I want to install Evans Waterless Coolant in my 2000 hardtop. The Evans folks say that all coolant should be drained from the engine block in order to prep it for the new waterless coolant. Since my car was already up on jack stands I began searching from below for the threaded expansion plugs...
When I bought my 2000 hardtop, in addition to a Borla cat-back exhaust system, it had a VaraRam C5 Power Duct, VaraRam V8 velocity stack and one of those inverted Y-shaped intake setups that have a cone filter on each end of the Y legs. I had removed the intake set up and found the velocity...
I did remove both the battery and battery tray, but couldn't see any vacuum lines, only electrical cables. I also removed the passenger side front wheel and the rear inner fender panel and eventually located the vacuum reservoir. I had limited access due to the control modules mounted in front...
The check engine light in my 2000 hardtop just came on. It's showing a P0410 code for Secondary Air Injection System. The car just turned over 50,000 miles. Is there a part that is more likely than the others in this system that might be the best place to start diagnosing the problem? Thanks for...
I have a 2000 hard top. I found an unused, small two-wire female electrical connector in the trunk behind the carpet on the passenger side quarter panel. It has small orange and black wires leading into it. I wanted to install some LED lights back there and thought that this connector might be a...
I figured this one out on my own.
OK, I remembered that I had a small flashlight in the glove compartment. Turns out that it was free to slide to the right side of the glove box but other stuff prevented it from sliding over to the other side. Every time I made a sharp left turn, it would slide...
My 2000 hard top started making a kind of popping sound in the right rear area when I turn left briskly. At first I thought it was something in the trunk but I wonder if it could be coming from the right rear hub. It has 47,198 miles on it and I don't race it. Does this sound familiar to anyone?
Braided Brake Hose problems link
To all of you who contributed to my thread on this subject, I thank you. Based on everyone's answers, I'll be installing the braided brake hoses. I managed to find the link to the GM service bulletin on this matter:
1997 - 2004 Corvette: GM TechLink: Stainless...
I have a 2000 hard top and have been thinking about replacing the brake hoses with braided stainless steel units. I've seen a couple things on the internet that claim that they interfere with the wheel speed sensors and produce error codes. Has anyone experienced this issue?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.