Recent content by Trance_LT4

Since you have a carbed vehicle, I think a wet kit would be more suited to you. I'm not an expert on carbed nitrous, but I don't think dry would work, since for a dry system to work, you need to have a device (The MAF sensor on most EFI vehicles) to sense the greater air density/more oxygen that...

Everything has worked out fine......I hope. I did move to Virginia. Its a new address, so Fed-Ex didn't know where it was at first, but since then they've delivered several packages to me. However, the Carputing package still sits in their warehouse this whole time, 20 miles away. That was half...

I saw the fax number and address on their webpage. #1 I don't own a fax #2 I'm not in the massachusets area. #3 Faxing and Snail mailing isn't any better than emailing. I would still have to wait for them to respond, just like an email. I want a phone conversation with a human being so I can...

Carputing, the makers of LT1 edit, don't have a phone number on their website anywhere, and its not listed with 411 directory assistance. My order for LT1 Edit is nearly a month overdue from the email of when I could expect it. I've emailed them 4 times without response. Do any of you who...

Hit 72000 last week or so

I've got a miss under WOT that starts around 5000 and higher, slightly lower in 4th and 5th. I know that this could be detonation, or my knock sensor getting a false reading pulling timing away. My question is about the other posibilities, like fuel starvation (doubtful), dirty injectors...

I woke up.......and it was there, all 18 disgusting inches. 8 more the next morning. Its all dug out now, and I just drove it down to the car wash.

I've been thinking about a new paint job.......but white over red wasn't what I had in mind.

I'm not using bullets from Random tech. I'm using two 12 inch cats I ordered from summit. Catco, I think the name is. They were like $40 a piece.

Maryland emmissions......I got my long tube headers done after my smog test. I've got less than a year before my next one is due, so I can't tell you yet, but I'm gonna try to get it smogged as is right now.

They should have pictures of the rims on the auction if they want them to sell. I don't care if its $2.00 for a working LT5 engine, I won't buy it without a picture

What kinda engine is this going on? If its not an LT1/LT4 (and I may be wrong about this, but I don't think so) you can't use an LT4 hotcam, cause its meant to also drive the water pump, a feature not incorporated into the L98 (TPI).

What kind of system is it again? Is it a cat-back, or does it connect at the manifolds and eliminate the cats? I am running rear O2 sensor eliminators, since my whole exhaust is aftermarket. You can order them from www.summitracing.com

Bumper stickers on any car are a waste. Do people actually think someone else cares what they find witty? Do I care about what politician you are voting for? No. People like that should keep thier opinions in their heads, behind their closed lips, and not on their cars, especially if its a...

Those funny little foam pieces only go on the back side to keep dirt from slipping under the filter in into the intake. Just a better seal. My K&N on the 96 LT4 fits just fine. I have a cut air lid, so its easier to look at the filter from the top side and line it up right before install. I...