I have the Edelbrock Performer RPM 7104 Intake Manifold, the Holley 108-118 base gasket, and the Holley 0-9895 carburetor. Will there be any need to increase primary jet size on carb with the upgrade of the intake from Performer to Performer RPM...
Good read and a lot to consider when making the switch. I am currently finishing my install to the Performer RPM 7104 from the Performer. There is a .70'' increase in height difference from the Performer to Performer RPM. Stock setup will not fit under the stock hood which has already been...
Well, I searched the forum and really didn't come up with much information on what hood i really need. Need some suggestions.
I have a 79 with complete Top-End Rebuild. Edelbrock RPM Intake Manifold with a Holley Carb. The Air cleaner is about 3.25''. The stock hood will obviously need to be...
12.5 volts at battery terminal and the same at the alternator but when I put the key in the start position the lights are dim and I have a voltage of 9 volts at battery and alternator. There is no clicking noise and the starter never cranks. All grounds and connections are good. When I turn the...
I have a '79 C3 Auto L48 with a complete Top-End Rebuild. She ran fine 3 weeks ago, I go out to start her up for a quick cruise and nothing. When I turn the key to start, no clicks, no crank but interior lights go dim. I have proper voltage at battery terminals and same voltage at generator...
Power Steering Cylinder?
Would a defective or failing power steering cylinder cause pulling to the right under moderate braking? I just replaced my power steering cylinder and the pulling to the right issue is much better. Weird...
New power steering cylinder installed. This one just looks so much better. The color and hardware scream quality over what I was previously sent the first time. ;) Hopefully they resolve the issues with the first vendor.
UPDATE:Corvette Central Power Steering Cylinder
After contacting Corvette Central about the issue of shaft threads and hardware (Washers and Nut) being incorrect they responded in kind and notified me that they agree there is an issue with the specific vendor they are dealing with and are...
Yes I do have this spacer installed. The correct cupped washers made a huge difference in spacing. The only nut that fits is the one that came with the cylinder. I'm going to Home Depot or Lowes to hopefully find a better quality nut to install and use loctite to ensure it doesn't back off and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.