I'm in negotiations to buy a 2004 and don't like the strip on the door ... what happens when you remove it? I need to know about the wheels also, I think they were an extra. Any info would be appreciated.
1990 Corvette, The fuse that controls the radio and windshield wipers keeps burning out. Sometimes it's within I mile of driving and the next time I replace the 25amp fuse it lasts for 3 or 4 days. Any ideas where the short could be?
:bash 1990 L98, Just installed a new Luk clutch and Luk flywheel. When I start the car and push the clutch pedal to the floor there is a distinct clicking noise which increases if I rev the engine with the clutch in, if I let the clutch up about 3/8" the noise stops. After driving the car or...
:beer Has anybody changed their earlier Vette to R134? If so does it get reasonably cold and have you encountered any other problems? Any input would be appreciated before Thursday 1/11/07. Thanks
:r When I shift from 1 to 2 or 3 to 4 there is a grinding noise as I pass through neutral. Other then that the transmission shifts just fine. This grinding noise happens intermittently. The transmission guy at the dealer said maybe it is the release bearing in the clutch and then said maybe I...
:r My 90 Vette failed the smog check in California. I took my car to my mechanic and he ran all the tests and no matter what he does the the car runs too lean. I installed Accel 21 fuel injectors and he thinks that's the problem as stock injectors are 22 and the engine can't get enough fuel...
:W Thinking of changing system to 134a as my A/C needs freon. I would be interested to know if anybody had done this and if satisfied with the car getting cold.
Has anybody had the problem of their 90 Vette idling at 1000 rpm and then the next time your drive the car it's normal and then it goes back up again. I've installed a new throttle body, IAC, oxygen sensor, adjustable fuel pressure regulatior. Mechanic thinks it might be the EMC. Any Ideas?
:r Both horns don't make any sound on my 90 when I depress the either button on the steering wheel. Could it be the relay or has anybody experienced other causes?
Car won't hold idle and dies at starting and takes hitting the gas and finally it will even out. A new idle air control valve has been installed and it still does'nt work. My mechanic installed a new EMC to see if that was the problem, it was not. NO codes come up when he tests the idle...
:Twist Need input on a problem I'm having with my 90 Vette 6 speed. When I take out from a dead stop in 1st to about 3000 and then shift into second and I'm at half throttle the engine seems to flatten out between 1800 and 2600, then it's strong again, the same thing happens at the same rpm in...
Has anybody out there installed a bulb for the speedometer on a 90 Vette? Is this something that should be left to the dealer? The light is on but is always dimmer then the other guages.:crazy
I'm planning on buying tires or my 90 Vette and I'm considering the kumho 712's but worried about the large center groove on this tire and how it reacts with the ribbed freeways in the Los Angeles area. Does it set up any vibrations and has anybody had any experience with this?:bang
fuel guage reads full until there is only 1/2 tank and then it reads correctly. amount of gas and range. are these units repairable or is a new sender the only answer?:r
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.