Search results

I am in the process of replacing an intake. I'd like to access the core plugs in the block to get all the old coolant out of the block. My question is this: will there be any damage to running the engine with no coolant or water, if only for a few minutes? I am mainly concerned about...

I am sure someone smarter than me will post otherwise, but as far as I know, harmonic balancer = balancing dampner = crankshaft dampner. I think the article was just showing an neat aftermarket balancer.

It is not my car or my decision, but if it were I would do things in this order: Sell or trade the square port manifold for an oval port. These are being reproduced now so there is no reason you can't find one. A square port manifold has value and there is no reason you can't do this for...

You have piqued my interest--what are you looking to have them restore?

Barry, the site looks good, but I agree that the font is a bit too small. Also, I am not a huge fan of the font type. The letters are not differentiated enough for my liking, but that is just me. Lastly, the whole italicized/shadowed font of the club name is hard to read. It is a good body...

By the way, the set up looks sweet so for. Good work . . .

3659 = list number 792 = 1967, 9th month, 2nd week (same pattern for other carbs, 0 = October) 3902363EU = part number I suspect your front carb is actually a 3902353? They seem to be a mix of 68 & 69 carbs.

you are looking for 2 holes on the driverside inner fender lip where the air cleaner used to be. Directly ahead of this on the radiator core support there should be an open hole where the fresh air intake hose would have gone. There should not be a plate there evidence or evidence that there...

Can one of the locals provide any information on local areas to stay? I am planning on attending the NCRS meet there in Jan. I'd like to rent a house and make it a vacatio for the whole family. Can someone recommend areas to consider from this list...

My March car is completely smooth as well. Keep in mind this is an observation and not a definative answer

I disagree with that statement. Unless you are towing or doing some serious hill climbing, the valve seats in cast iron heads will be just fine for most of us without hardened seats or TEL. It is true that recession will occur, but at a rate that is so slow it will take years for it to...

http://www.z28camaro.com/restosvcs.html